The Femto series FWPR-20 photoreceivers combine low noise Si or InGaAs PIN photodiodes with a specially designed transimpedance amplifier with extremely high gain of up to 1012 V/A and very low noise. This unique combination results in a photoreceiver with Femtowatt sensitivity due to its exceptional low NEP of 0.7 fW/√Hz. Direct detection of optical powers down to ca. 50 fW is possible without the need for further averaging behind the receiver.
FEATURES
-
Ultra-low-noise – NEP 0.7 fW/√Hz
-
Transimpedance amplifier with high gain up to 10^12 V/A included
-
Wavelength range from 320 nm to 1700 nm
ULTRA HIGH SENSITIVITY AND VERY LOW NOISE
REPLACE YOUR EXPENSIVE APD, PMT, OR LN2 COOLED IR DETECTOR
Due to their very high sensitivity the FEMTO FWPR-20 series photoreceivers can replace APDs, PMTs and cooled Ge photodiodes in many applications. No expensive high voltage power supply or cooling is required.
The FWPR-20-SI offers high quantum efficiency in the visible and near infrared similar to that of APD based single photon counting modules. In applications where timing is uncritical, e.g. when the signal of a photon counter is integrated for a few 10 ms or more, the FWPR-20-SI photoreceiver achieves a comparable signal-to-noise ratio at a fraction of the cost.
For NIR spectroscopy the InGaAs model FWPR-20-IN achieves similar results as a much more expensive and complex system based on a liquid nitrogen cooled Germanium detector with external amplifier. As a result of the already integrated very low noise, high gain amplifier, signals in the Volt range can be achieved directly at the output of the FWPR-20 Femtowatt photoreceiver.
APPLICATIONS
-
Fluorescence measurements
-
Spectroscopy
-
Electrophoresis
-
Chromatography
-
Replacement for photomultiplier tubes (PMTs), avalanche photodiodes (APDs) and liquid nitrogen cooled germanium photodiodes
|
Model |
FWPR-20-SI |
FWPR-20-IN |
|
Photodiode |
1.1 x 1.1 mm2 Si |
0.5 mm Ø InGaAs PIN |
|
Spectral Range |
320 ... 1100 nm |
900 ... 1700 nm |
|
Bandwidth (−3 dB) |
DC ... 20 Hz |
DC ... 20 Hz |
|
Rise/Fall Time (10 % - 90 %) |
18 ms |
18 ms |
|
Transimpedance Gain |
1 x 1012 V/A |
1 x 1011 V/A |
|
Max. Conversion Gain |
0.6 x 1012 V/W (@ 960 nm) |
0.95 x 1011 V/W (@ 1550 nm) |
|
NEP (@ 1 Hz) |
0.7 fW/√Hz (@ 960 nm) |
7.5 fW/√Hz (@ 1550 nm) |
|
Datasheet |
Output voltage ±10 V max (@ 100 kΩ load). Offset adjustable by potentiometer. Units with fiber optic input are optionally available. Output short-circuit protected. Threaded M4 and 8-32 mounting holes for use with standard mounting posts. Power supply ±15 V via 3-pin Lemo® socket. A mating connector is provided with the device. Optional power supply PS-15 available. For further information please view the datasheet or contact FEMTO.